Examples
The following example shows how to configure that no action is performed on the interface when an Ethernet
OAM session goes down.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# action session-down disable
The following example shows how to configure putting the interface into the line-protocol-down state when
an Ethernet OAM session goes down.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# action session-down efd
The following example shows how to configure that the interface is put into the error-disable state when an
Ethernet OAM session goes down.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# action session-down error-disable-interface
The following example shows how to configure that a syslog entry is created when an Ethernet OAM session
goes down. This configuration overrides the interface Ethernet OAM profile.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/0
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
RP/0/RSP0/CPU0:router(config-if-eoam)# action session-down log
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration mode.ethernet oam profile, on page 215
Enables Ethernet Link OAM, with default values, on an interface
and enter interface Ethernet OAM configuration mode.
ethernet oam, on page 212
Attaches an Ethernet OAM profile to an interface.profile (EOAM), on page 299
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
148
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
action session-down
To Next Page
Loading...
Need help?
General
