frame-period window
To configure the window size for an Ethernet OAM frame-period error event, use the frame-period window
command in Ethernet OAM link monitor or interface Ethernet OAM link monitor configuration mode. To
return the window size to the default value, use the no form of this command.
frame-period window window
no frame-period window window
Syntax Description
Size of the window for a frame-period error in milliseconds. The range is 100 to 60000.
The only accepted values are multiples of the line card-specific polling interval,
that is, 1000 milliseconds for most line cards.
Note
window
Command Default
The default value is 1000.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
The IEEE 802.3 standard defines the window size as number of frames rather than a time duration. These two
formats can be converted either way by using a knowledge of the interface speed. Note that the conversion
assumes that all frames are of the minimum size.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the window size for a frame-period error.
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame-period window 60000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
251
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame-period window
To Next Page
Loading...
Need help?
General
