Cisco ASR 9000 Series Command Reference Guide

frame-relay intf-type
To configure the interface type of the User-Network Interface (UNI), use the frame-relay intf-type command
in interface configuration mode. To change the configuration, use the no form of this command.
frame-relay intf-type {dce| dte| nni}
no frame-relay intf-type {dce| dte| nni}
Syntax Description
Router functions as a switch connected to a router.dce
Router is connected to a Frame Relay network.dte
Router is connected to a NNI signaling interface.nni
Command Default
DTE
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
The nni keyword was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay intf-type command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to configure a DCE switch type on the interface:
RP/0/RSP0/CPU0:router(config)# interface pos 0/4/0/0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
431
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay intf-type

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model