Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

Task ID
OperationsTask ID
read, writebundle
Examples
The following example shows how to set the number of active links required to bring up a specific bundle.
In this example, the user sets the required number of active links required to bring up Ethernet bundle 5 to 2:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 5
RP/0/RSP0/CPU0:router(config-if)# bundle maximum-active links 1
Related Commands
DescriptionCommand
Sets the number of active links required to bring up a specific
bundle.
bundle minimum-active links, on page 581
Displays information about configured bundles.show bundle, on page 619
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
579
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle maximum-active links