Cisco ASR 9000 Series - Ssrp Group

ssrp group
To attach an Session State Redundancy Protocol (SSRP) group on an interface, use the ssrp group command
in interface configuration mode. To remove the SSRP group from the interface, use the no form of this
command.
ssrp group group-number id id-number ppp
Syntax Description
SSRP group number. The range is 1 to 65535.
group-number
SSRP identifier number. The range is 1 to 4294967295.
id id-number
Specifies point-to-point protocol.ppp
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The group must be configured first on a specific location (linecard) and then assigned to the interface. The
redundancy ID must be unique within the group. This command specifies a list the protocols that the group
can replicate. Currently only PPP is supported.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface Multilink 0/1/0/0/1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
771
PPP Commands onthe Cisco ASR 9000 Series Router
ssrp group