report sf-ber disable
To disable Signal Failure (SF) Bit Error Rate (BER) reporting, use the report sf-ber disable command in
wanphy configuration mode. To enable Signal Failure (SF) Bit Error Rate (BER) reporting, use the no form
of this command. In the case of A9K-8X100GE-SE line cards, the commands report sf-ber and no report
sf-ber are used to enable and disable SF BER respectively.
report sf-ber disable
no report sf-ber disable
Syntax Description
This command has no keywords or arguments.
Command Default
Signal Failure (SF) Bit Error Rate (BER) reporting is enabled by default.
Command Modes
Wanphy configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to disable Signal Failure (SF) Bit Error Rate (BER) reporting.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/1/0
RP/0/RSP0/CPU0:router(config-wanphy)# report sf-ber disable
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
DescriptionCommand
Enables Signal Degrade (SD) Bit Error Rate (BER) reporting.report sd-ber, on page 1102
Displays alarms, registers, and module information for a 10-Gigabit
Ethernet WAN PHY controller.
show controllers wanphy, on page 1105
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1103
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
report sf-ber disable
To Next Page
Loading...
Need help?
General
