Cisco ASR 9000 Series - Page 1124

Cisco ASR 9000 Series

1138 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

DescriptionCommand

Configures the threshold of the SF BER that is used to trigger a

link state change.

threshold sf-ber, on page 1116

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x

1104

10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router

report sf-ber disable

Table of Contents

Default Chapter3
- Table of Contents3
Preface19
- Changes to this Document19
- Obtaining Documentation and Submitting a Service Request19
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router21
Related Commands92
Rp/0/Rsp0/Cpu0:Router(Config)# Controller Dwdm92
- Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference92
Description94
- Displays Optical Parameters, G.709 Alarms and Counters, and Register94
- Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference95
Ethernet Interface Commands on the Cisco ASR 9000 Series Router95
Ethernet OAM Commands on the Cisco ASR 9000 Series Router151
Chapter 4 Frame Relay Commands on the Cisco ASR 9000 Series Router442
Chapter 5 Global Interface Commandsonthe Cisco ASR 9000 Series Router513
Internal Ethernet Control Network Commands on the Cisco ASR 9000 Series Router553
Integrated Routing and Bridging Commands on the Cisco ASR 9000 Series Router573
Chapter 8 Link Bundling Commands on the Cisco ASR 9000 Series Router584
Management Ethernet Interface Commands on the Cisco ASR 9000 Series Router685