Cisco ASR 9000 Series Command Reference Guide

delay clear
To configure the amount of time before a Synchronous Transport Signal (STS) path delay trigger alarm is
cleared, use the delay clear command in STS path configuration mode. To return the command to its default
setting, use the no form of this command.
delay clear value
no delay clear value
Syntax Description
Value, in milliseconds, before an STS path delay trigger alarm is cleared. The range is
from 0 to 180000. The default is 10 seconds.
value
Command Default
The default is 10 seconds.
Command Modes
STS path configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify that STS path delay trigger alarms should be cleared after 7000
milliseconds:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/2/0/3
RP/0/RSP0/CPU0:router(config-sonet)# sts 1
RP/0/RSP0/CPU0:router(config-stsPath)# delay clear 7000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
859
SONET Controller Commands on the Cisco ASR 9000 Series Router
delay clear

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model