isolation recovery-delay
To specify a delay before clearing the isolation condition after recovery from failure, use the isolation
recovery-delay command in the redundancy group ICCP configuration mode. To return to the default value,
use the no form of this command.
isolation recovery-delay seconds
no isolation recovery-delay seconds
Syntax Description
Recovery delay in seconds.
seconds
Command Default
By default, the delay is set to 180 seconds.
Command Modes
Redundancy group ICCP configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Examples
This example shows how to configure ICCP parameters:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# isolation recovery-delay 35
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)#
Task ID
OperationsTask ID
read, writeconfig-services
Related Commands
DescriptionCommand
Configures Inter Chassis Communication Protocol (ICCP)
parameters.
redundancy iccp group, on page 617
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
591
Link Bundling Commands on the Cisco ASR 9000 Series Router
isolation recovery-delay
To Next Page
Loading...
Need help?
General
