tcp compression
To enable TCP compression in an IP header compression (IPHC) profile, use the tcp compression command
in IPHC profile configuration mode. To disable TCP compression in the profile, use the no form of this
command.
tcp compression
no tcp
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Where the IPHC profile used by a router is configured using this command, the router will negotiate TCP
compression with its peer router and decompress any compressed TCP packets sent by its peer. TCP packets
transmitted to the peer are transmitted uncompressed.
TCP compression can be enabled only within an IPHC profile. TCP compression does not work unless it
is enabled under a profile.
Note
Task ID
OperationsTask ID
read, writeip-services
Examples
The following example shows how to enable TCP compression within an IP header compression (IPHC)
profile:
RP/0/RSP0/CPU0:router(config)# config
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
826
Serial Interface Commands on the Cisco ASR 9000 Series Router
tcp compression
To Next Page
Loading...
Need help?
General
