frame window
To configure the frame window size of an OAM frame error event, use the frame window command in
Ethernet OAM link monitor or interface Ethernet OAM link monitor configuration mode. To return the window
size to the default value, use the no form of this command.
frame window window
no frame window window
Syntax Description
Size of the window for a frame error in seconds. The range is 1000 to 60000.
window
Command Default
The default value is 1000.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the window size for a frame error.
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame window 60
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
258
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame window
To Next Page
Loading...
Need help?
General
