bundle minimum-active links
To set the number of active links required to bring up a specific bundle, use the bundle minimum-active
links command in interface configuration mode.
bundle minimum-active links links
Syntax Description
Minimum number of active links allowed in the specified bundle.
The range is from 1 through 64.
links
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The command range maximum was changed from 8 to 64.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
The following example shows how to set the number of active links required to bring up a specific bundle.
In this example, the user configures Ethernet bundle 5 so that 2 links must be active before the bundle can
be brought up:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 5
RP/0/RSP0/CPU0:router(config-if)# bundle minimum-active links 2
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
581
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle minimum-active links
To Next Page
Loading...
