show interfaces (frame relay)
To display statistics about Frame Relay interfaces, use the show interfaces command in EXEC mode.
show interfaces [summary| [type interface-path-id] [brief| description| detail| accounting [rates]]] [location
node-id]
Syntax Description
(Optional) Displays a summary of interface information by interface type.summary
(Optional) Interface type. For more information, use the question mark (?) online
help function.
type
(Optional) Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Displays brief information about each interface (one line per interface).brief
(Optional) Displays an interface description.description
(Optional) Displays detailed information about each interface. This is the default.detail
(Optional) Displays the number of packets of each protocol type that have been
sent through the interface.
accounting
(Optional) Displays interface accounting rates.rates
(Optional) Displays information about all interfaces on the specified node. The
node-id argument is entered in the rack/slot/module notation.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introducedRelease 4.0.0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
486
Frame Relay Commands on the Cisco ASR 9000 Series Router
show interfaces (frame relay)
To Next Page
Loading...
Need help?
General
