(Optional) Specifies the type of statistics to collect:
• one-way-loss-ds—One-way loss statistics
from destination to source.
• one-way-loss-sd—One-way loss statistics
from source to destination.
statistics measure
(Optional) Specifies that statistics are not
aggregated into bins, and each statistic is stored
individually.
This option can be memory-intensive
and should be used with care.
Caution
aggregate none
(Optional) Specifies the number of bins (from 2 to
100) within each bucket to store sample packets
from the probe. The default is to aggregate into one
bin.
aggregate bins number
Specifies the range of the samples to be collected
within each bin in percentage points, from 1 to 100.
width count
(Optional) Specifies the number of buckets to store
in memory from 1 to 100. The default is 100.
buckets archive number
(Optional) Specifies the number of buckets to be
used for probes from 1 to 100. The default is 1.
buckets size number
Specifies that probes span multiple buckets.per-probe
Specifies that buckets span multiple probes.probes
(Optional) Specifies that the probe begins as soon
as you enter the command. This is the default.
schedule now
(Optional) Specifies a specific time at which to start
the probe in 24-hour notation.
schedule at hh:mm
(Optional) Number of seconds into the next minute
at which to start the probe.
ss
(Optional) Number in the range 1 to 31 of the day
of the month on which to start the probe.
day
(Optional) Name of the month (full word in
English) in which to start the probe.
month
(Optional) Year (fully specified as 4 digits) in which
to start the probe.
year
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
241
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-synthetic-loss-measurement probe
To Next Page
Loading...
Need help?
General
