Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows sample output for the show lldp interface command for the Gigabit Ethernet
interface at 0/1/0/7:
RP/0/RSP0/CPU0:router# show lldp interface gigabitethernet 0/1/0/7
Wed Apr 13 13:22:30.501 DST
GigabitEthernet0/1/0/7:
Tx: enabled
Rx: enabled
Tx state: IDLE
Rx state: WAIT FOR FRAME
Table 6: show lldp interface Field Descriptions
DescriptionField
Configuration status of the interface to transmit LLDP
advertisements.
Tx:
Configuration status of the interface to receive LLDP
advertisements.
Rx:
Status of the LLDP transmit process on the interface.Tx state:
Status of the LLDP receive process on the interface.Rx state:
Related Commands
DescriptionCommand
Enables LLDP globally for both transmit and receive operation
on the system.
lldp, on page 87
Enters LLDP configuration mode.lldp (interface), on page 89
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
117
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
show lldp interface

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model