show ethernet oam discovery
To display the currently configured OAM information of Ethernet OAM sessions on interfaces, use the show
ethernet oam discovery command in EXEC mode.
show ethernet oam discovery [brief| interface type interface-path-id [remote]]
Syntax Description
Displays minimal, currently configured OAM information in table form.brief
(Optional) Displays information about the specified interface type. For more
information, use the question mark (?) online help function.
interface type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Retrieves and displays information from a remote device, as if the
command was run on the remote device.
remote
Command Default
Displays detailed information for Ethernet OAM sessions on all interfaces.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
369
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet oam discovery
To Next Page
Loading...
Need help?
General
