ppp max-configure
To specify the maximum number of configure requests to attempt (without response) before stopping the
requests, use the ppp max-configure command in an appropriate configuration mode. To disable the maximum
number of configure requests and return to the default, use the no form of this command.
ppp max-configure retries
no ppp max-configure
Syntax Description
Maximum number of retries. Range is 4 through 20. Default is 10.
retries
Command Default
retries: 10
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
This command was supported in the dynamic template configuration
mode for BNG.
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the ppp max-configure command to specify how many times an attempt is made to establish a Link
Control Protocol (LCP) session between two peers for a particular interface. If a configure request message
receives a reply before the maximum number of configure requests are sent, further configure requests are
abandoned.
Task ID
OperationsTask ID
read, writeppp
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
732
PPP Commands onthe Cisco ASR 9000 Series Router
ppp max-configure
To Next Page
Loading...
Need help?
General
