bert interval
To specify the duration of a bit error rate test (BERT) pattern on a T3/E3 or T1/E1 line, use the bert interval
command in the appropriate configuration mode. To revert to the default interval, use the no form of this
command.
bert interval time
no bert interval time
Syntax Description
Duration (in minutes) of the BERT. The interval can be a value from 1 to 14400. The
default is 1 minute.
time
Command Default
A BERT runs for 1 minute.
Command Modes
T3 configuration
E3 configuration
T1 configuration
E1 configuration
Channel group configuration for T1 and E1
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Support for E3 and E1 configuration mode was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the bert interval command with the bert pattern command. If the bert interval command is not used,
then the BERT runs for a default of 1 minute.
Task ID
OperationsTask ID
read, writesonet-sdh
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
945
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
bert interval
To Next Page
Loading...
Need help?
General
