Cisco ASR 9000 Series Command Reference Guide

tug3
To specify the tributary unit group (TUG) number and enter the TUG3 controller configuration mode, use
the tug3 command in SONET controller configuration mode.
tug3 number
Syntax Description
The tributary unit group (TUG) number. The ranges are:
• AU4—The only value is 1.
• AU3—The range is 1 to 3.
number
Command Default
The default is 1.
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The tug3 command enables you to begin configuring the interface in the TUG3 controller configuration mode,
where you can configure virtual containers (VCs) and DS3s:
STM1 -> AU4 -> TUG3 -> VC-3 -> DS3
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify tug3 1.
RP/0/RSP0/CPU0:router(config)# controller sonet 0/1/0/0
RP/0/RSP0/CPU0:router(config-sonet)# au 1
RP/0/RSP0/CPU0:router(config-auPath)# tug3 1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
927
SONET Controller Commands on the Cisco ASR 9000 Series Router
tug3

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model