frame-seconds window
To configure the window size for the OAM frame-seconds error event, use the frame-seconds window
command in Ethernet OAM link monitor or interface Ethernet OAM link monitor configuration mode. To
return the window size to the default value, use the no form of this command.
frame-seconds window window
no frame-seconds window window
Syntax Description
Size of the window for a frame-seconds error in milliseconds. The range is 10000 to
900000.
The only accepted values are multiples of the line card-specific polling interval,
that is, 1000 milliseconds for most line cards.
Note
window
Command Default
The default value is 60000.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the window size for a frame-seconds error.
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame-seconds window 900000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
254
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame-seconds window
To Next Page
Loading...
Need help?
General
