g709 otu report disable
To disable the logging of selected Optical Channel Transport Unit (OTU) alarms to the console for a DWDM
controller, use the g709 otu report disable command in DWDM configuration mode. To return to the default
state, use the no form of this command.
g709 otu report {bdi| fecmismatch| iae| lof| lom| los| sd-ber| sf-ber| tim} disable
no g709 otu report {bdi| fecmismatch| iae| lof| lom| los| sd-ber| sf-ber| tim} disable
Syntax Description
Backward defect indication reporting status.bdi
FEC mismatch alarm reporting status.
FEC mismatch alarm is
deprecated.
Note
fecmismatch
Incoming alignment error reporting status.iae
OTU loss of frame reporting status.lof
Loss of multiple frame reporting status.lom
Loss of signal reporting status.los
SM bit error rate (BER) is in excess of the signal degradation BER threshold.sd-ber
SM BER is in excess of the signal failure BER threshold.sf-ber
Trace Identifier Mismatch reporting status.tim
Command Default
Reporting is enabled for all keywords.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
17
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 otu report disable
To Next Page
Loading...
Need help?
General
