group
To create a Session State Redundancy Protocol (SSRP) group and associate it with a profile, use the group
command in global configuration mode. To remove this group, use the no form of this command.
group group-id profile profile_name [default]
no group group-id profile profile_name [default]
Syntax Description
SSRP group identifier. The range is 1 to 65535.
group-id
Profile to associate with this group.
profile profile_name
Associates the group to the default profile.default
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Any interfaces on this card can be configured to use this group. The group number must be unique across the
router.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to create an SSRP group:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# ssrp location 0/1/cpu0
RP/0/RSP0/CPU0:router(config-ssrp-node)# group 1 profile default
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
716
PPP Commands onthe Cisco ASR 9000 Series Router
group
To Next Page
Loading...
Need help?
General
