link-monitor
To enter Ethernet OAM link monitor configuration mode, use the link-monitor command in Ethernet OAM
configuration mode. To enter interface Ethernet OAM link monitor configuration mode, use the link-monitor
command in interface Ethernet OAM configuration mode.
link-monitor
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to enter the Ethernet OAM link monitor configuration mode.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)#
The following example shows how to enter the link monitor configuration mode from interface Ethernet OAM
configuration mode.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
RP/0/RSP0/CPU0:router(config-if-eoam)# link-monitor
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
262
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
link-monitor
To Next Page
Loading...
Need help?
General
