Cisco ASR 9000 Series - Service

service
To associate a service with a domain and enter CFM domain service configuration mode, use the service
command in CFM domain configuration mode. To remove a service from a domain, use the no form of this
command.
service service-name {bridge group bridge-domain-group bridge-domain bridge-domain-name| down-meps|
xconnect group xconnect-group-name {p2p xconnect-name | mp2mp xconnect-name ce-id ce-id-value
remote-ce-id remote-ce-id-value}} [id [icc-based icc-string umc-string] | | [string text]| [number number]|
[vlan-id id-number]| [vpn-id oui-vpnid]]
no service service-name {bridge group bridge-domain-group bridge-domain bridge-domain-name|
down-meps| xconnect group xconnect-group-name {p2p xconnect-name | mp2mp xconnect-name ce-id
ce-id-value remote-ce-id remote-ce-id-value}} [id [icc-based icc-string umc-string] | | [string text]| [number
number]| [vlan-id id-number]| [vpn-id oui-vpnid]]
Syntax Description
Administrative name for the service. Case sensitive ASCII string up to 80
characters.
Used in conjunction with one of the following service types:
•
bridge
•
down-meps
•
xconnect
service-name
Specifies the use of a bridge domain. Used in conjunction with group and
bridge-domain.
When bridge is specified, all MEPs are up and MIPs are permitted.Note
bridge
Specifies the name of the bridge domain group.
group bridge-domain-group
Specifies the name of the bridge domain and enters the Ethernet CFM domain
service mode.
bridge-domain
bridge-domain-name
Specifies that all MEPs are down and no MIPs are permitted.down-meps
Specifies the use of a cross connect. Used in conjunction with group and
p2p or mp2mp.
When xconnect is specified, all MEPs are up and MIPs are
permitted.
Note
xconnect
Specifies the name of the cross connect group.
group xconnect-group-name
Specifies the name of the point-to-point cross connect and enters the Ethernet
CFM domain service mode.
p2p xconnect-name
Specifies the name of the multipoint-to-multipoint cross connect and enters
the Ethernet CFM domain service mode.
mp2mp xconnect-name
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
314
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
service