Cisco ASR 9000 Series - Mlacp System Mac

mlacp system mac
To configure the LACP system ID to be used in an ICCP group, use the mlacp system mac command in the
redundancy ICCP group configuration mode. To return to the default value, use the no form of this command.
mlacp system mac mac-id
no mlacp system mac mac-id
Syntax Description
Specifies the unique ID for the system.
A non-zero value is
permitted.
Note
mac-id
Command Default
No default behavior or values
Command Modes
Redundancy ICCP group configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
The following example shows how to configure the LACP system ID to be used in an ICCP group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# mlacp system mac 1.1.1
Related Commands
Configures ICCP parameters.redundancy iccp group
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
613
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp system mac