show iphc trace all
To display trace results for all IP header compression (IPHC) configurations on the router, use the show iphc
trace all command in EXEC mode.
show iphc trace all [unique| wrapping] [hexdump] [last number-of-entries] [reverse] [stats] [tailf] [verbose]
[file file-name original location node-id| location {node-id| all| mgmt-nodes}]
Syntax Description
(Optional) Displays trace information for unique entries with counts.unique
Optional) Displays wrapping entries.wrapping
(Optional) Displays trace information in hexadecimal format.hexdump
(Optional) Displays trace information for the last specified number of entries.
The range is from 1 to 4294967295.
last number_of_entries
(Optional) Displays trace information in reverse order (latest traces first).reverse
(Optional) Displays statistics information for the trace.stats
(Optional) Displays new traces as they are added.tailf
(Optional) Displays internal debugging information.verbose
(Optional) Displays trace information for the specified file.
file file_name
(Optional) Specifies the original location of file.original
(Optional) Displays trace information for the specified card location.
location node_id
(Optional) Displays trace information for all nodes.all
(Optional) Displays trace information for all management nodes.mgmt-nodes
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
821
Serial Interface Commands on the Cisco ASR 9000 Series Router
show iphc trace all
To Next Page
Loading...
Need help?
General
