Cisco ASR 9000 Series Command Reference Guide

mlacp switchover type
To specify a non-default switchover method , use the mlacp switchover typecommand in the bundle interface
configuration mode.
mlacp switchover type [ brute-force | revertive ]
Syntax Description
Force switchover by disabling all local member links.brute-force
Revert based on configured priority values.revertive
Command Default
The default switchover type is non-revertive.
Command Modes
Bundle interface configuration.
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator.
The brute-force and revertive options are mutually exclusive, and the value must match on the bundle on
both POAs. They determine whether the dynamic priority management or brute force mechanism is used, and
whether the behavior is revertive or non-revertive.
Task ID
OperationTask ID
read, writeinterface
Examples
The following example shows how to force a switchover by disabling all local member links on an bundle-ether
interface:
RP/0/RSP0/CPU0:router(config-if)#mlacp switchover type brute-force
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
508
Global Interface Commandsonthe Cisco ASR 9000 Series Router
mlacp switchover type

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model