mlacp node
To configure the mLACP node ID to be used in the ICCP group, use the mlacp node command in the
redundancy ICCP group configuration mode. To return to the default value, use the no form of this command.
mlacp node node-id
no mlacp node node-id
Syntax Description
Specifies the unique node ID in the ICCP group for this system. The node-id value
ranges between 0 to 7.
node-id
Command Default
No default behavior or values
Command Modes
Redundancy ICCP group configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
This example shows how to configure the mLACP node ID to be used in the ICCP group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# mlacp node 3
Related Commands
Configures ICCP parameters.redundancy iccp group
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
611
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp node
To Next Page
Loading...
