line delay clear
To configure the amount of time before a SONET/SDH line delay trigger alarm is cleared, use the line delay
clear command in SONET controller configuration mode. To return the command to its default setting, use
the no form of this command.
line delay clear value
no line delay clear
Syntax Description
Value, in milliseconds, before a SONET/SDH line delay trigger alarm is cleared. The
range is 1000 to 180000. The default is 10.
value
Command Default
The default is 10.
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If the timer for the SONET/SDH line delay clear expires, an alarm is cleared.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify that SONET/SDH line delay trigger alarms should be cleared
after 4000 milliseconds:
RP/0/RSP0/CPU0:router(config)# controller SONET 0/0/0/2
RP/0/RSP0/CPU0:router(config-sonet)# line delay clear 4000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
866
SONET Controller Commands on the Cisco ASR 9000 Series Router
line delay clear
To Next Page
Loading...
Need help?
General
