Cisco ASR 9000 Series - Threshold Sd-Ber

threshold sd-ber
To configure the threshold of the Signal Degrade (SD) Bit Error Rate (BER) that is used to trigger a signal
degrade alarm, use the threshold sd-ber command in wanphy configuration mode. To return the Signal
Degrade (SD) Bit Error Rate (BER) to the default value, use the no form of this command.
threshold sd-ber exponent
no threshold sd-ber exponent
Syntax Description
Value of 10 raised to the n power, where n is the exponent of 10, as in10-n. Valid
values are 3 to 9, meaning 10-3 to 10-9.
exponent
Command Default
The default is 6, meaning (10-6).
Command Modes
Wanphy configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to configure sd-ber threshold:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/1/0
RP/0/RSP0/CPU0:router(config-wanphy)# threshold sd-ber 9
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
DescriptionCommand
Enables Signal Degrade (SD) Bit Error Rate (BER) reporting.report sd-ber, on page 1102
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1114
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
threshold sd-ber