member neighbor
To configure interchassis group ICCP members, use the member neighbor command in redundancy ICCP
group configuration mode. To return to the default behavior, use the no form of this command.
member neighbor neighbor-ip-address
no member neighbor neighbor-ip-address
Syntax Description
Specifies the ICCP member neighbor IP address.
neighbor-ip-address
Command Default
None
Command Modes
Redundancy ICCP group configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
The following example shows how to configure interchassis group ICCP members:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# member neighbor 10.1.1.1
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)#
Related Commands
DescriptionCommand
Configures Inter Chassis Communication Protocol (ICCP)
parameters.
redundancy iccp group, on page 617
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
607
Link Bundling Commands on the Cisco ASR 9000 Series Router
member neighbor
To Next Page
Loading...
Need help?
General
