Cisco ASR 9000 Series Command Reference Guide

(Optional) Timeout value (in seconds) for the specified interface. For a basic
traceroute, the timeout is a fixed value that defaults to 5 seconds. For an
exploratory traceroute, a logarithmic algorithm is used unless this value is
specified.
timeout seconds
(Optional) Sets whether or not the remote maintenance points should base their
responses on the filtering database only. The default is no—use both the filtering
and MIP-CCM databases.
The filtering-db-only option is only available for basic traceroute (when
the MAC address or MEP ID is specified). It is not available with the
explore option.
Note
filtering-db-only
(Optional) Identifies the class of traffic of the source MEP by setting a Class of
Service (CoS) value. The valid values are from 0 to 7.
cos cos-no
Specifies the initial time-to-live (TTL) value (from 1 to 255) for the traceroute
message. The default is 64.
ttl ttl
(Optional) Specifies that details are displayed in the output for the traceroute.detail
Command Default
No default behavior or values
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
By default, this command pauses until the traceroute operation is complete, then displays the results. If the
asynchronous option is used, this command returns immediately and no results are displayed. Results are
placed placed the traceroute cache and can be retrieved using the show ethernet cfm traceroute-cache
command.
An exploratory traceroute, by default uses a timeout value that is calculated by a logarithmic delay algorithm.
If the timeout value is specified, the specified value is used.
The display output of this command is similar to the output of the show ethernet cfm traceroute-cache
command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
416
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
traceroute ethernet cfm

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model