Cisco ASR 9000 Series Command Reference Guide

speed (DS0)
To specify the speed of the underlying DS0s in a channel group, use the speed command in channel group
configuration mode. To revert to the default speed, use the no form of this command.
This command is not applicable for E1 controllers.Note
speed kbps
no speed kbps
Syntax Description
Speed of the underlying DS0s in kilobits per second (kbps). Valid values are 56 and
64. The default is 64 kbps.
kbps
Command Default
The default speed is 64 kbps.
Command Modes
Channel group configuration for T1
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
Before the channel group configuration is valid, you must define the associated DS0 time slots using the
timeslots command.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to define the speed for the underlying DS0 to be 56 kbps:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1e1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1e1-channel_group)# speed 56
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1067
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
speed (DS0)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model