Cisco ASR 9000 Series Command Reference Guide

sts
To specify the Synchronous Transport Signal (STS) path and enter the STS controller configuration mode,
use the sts command in SONET controller configuration mode.
sts number
Syntax Description
STS path number. The range varies by the type of line card.
number
Command Default
No default behavior or values
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify STS 1:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/1/0/0
RP/0/RSP0/CPU0:router(config-sonet)# sts 1
RP/0/RSP0/CPU0:router(config-stsPath)#
Related Commands
DescriptionCommand
Specifies the administrative unit (AU) group number and enters the AU
controller configuration mode.
au, on page 844
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
920
SONET Controller Commands on the Cisco ASR 9000 Series Router
sts

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model