action discovery-timeout
To configure what action is taken on an interface when a connection timeout occurs, use the action
discovery-timeout command in Ethernet OAM configuration mode or interface Ethernet OAM configuration
mode. To return to the default, use the no form of this command.
action discovery-timeout {disable| efd error-disable-interface| log}
no action discovery-timeout {disable| efd error-disable-interface| log}
Syntax Description
Performs no action on the interface when a connection timeout occurs.disable
Puts the line protocol into the down state for an interface when a connection timeout
occurs. The state is removed when the session is re-established.
efd
Puts the interface into the error-disable state when a connection timeout occurs.error-disable-interface
(Interface Ethernet OAM configuration only) Creates a syslog entry when a
connection timeout occurs. This action is available only in interface Ethernet OAM
configuration mode to override the OAM profile on a specific interface.
log
Command Default
The default action is to create a syslog entry.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The efd keyword was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
139
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
action discovery-timeout
To Next Page
Loading...
