Cisco ASR 9000 Series Command Reference Guide

The flow-control command is supported on Gigabit Ethernet, TenGigE interfaces only; the flow-control
command is not supported on Management Ethernet Interfaces.
Note
The flow-control command syntax options may vary, depending on the type of PLIM or SPA that is
installed in your router.
Note
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to enable the sending of flow-control pause frames for ingress traffic on the TenGigE
interface 0/3/0/0:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/3/0/0
RP/0/RSP0/CPU0:router(config-if)# flow-control ingress
Related Commands
DescriptionCommand
Displays statistics for all interfaces configured on the router or for
a specific node.
show interfaces, on page 516
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
84
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
flow-control

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model