lacp system priority
To configure the priority for the current system, enter the lacp system priority command in global configuration
mode. To return to the default LACP system priority value, use the no form of this command.
lacp system priority priority
no lacp system priority priority
Syntax Description
Priority for this system. Replace priority with a number. Range is from 1 through 65535. A
lower value is higher priority.
s
Command Default
The default setting is priority = 32768.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The system priority value forms part of the LACP system ID, which is transmitted within each LACP packet.
The system ID, port ID and key combine to uniquely define a port within a LACP system.
Task ID
OperationsTask ID
read, writebundle
Examples
The following example shows how to configure an LACP priority of 100 on a router:
RP/0/RSP0/CPU0:router(config)# lacp system priority 100
The following example shows how to configure an LACP priority of 10 and MAC address on the Bundle-Ether
interface:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
605
Link Bundling Commands on the Cisco ASR 9000 Series Router
lacp system priority
To Next Page
Loading...
Need help?
General
