Cisco ASR 9000 Series Command Reference Guide

ppp ipcp neighbor-route disable
To disable installation of a route to the peer address negotiated by Internet Protocol Control Protocol (IPCP),
use the ppp ipcp neighbor-route disable command in interface configuration mode. To re-enable installation
of a route to the peer address negotiated by IPCP, use the no form of this command.
ppp ipcp neighbor-route disable
no ppp ipcp neighbor-route disable
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to disable installation of a route to the peer address negotiated by IPCP:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ppp ipcp neighbor-route disable
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
728
PPP Commands onthe Cisco ASR 9000 Series Router
ppp ipcp neighbor-route disable

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model