Cisco ASR 9000 Series - Log Continuity-Check Mep Changes

log continuity-check mep changes
To enable logging of peer maintenance-end-point (MEP) state changes, use the log continuity-check mep
changes command in CFM domain service configuration mode. To disable logging of peer MEP state changes,
use the no form of this command.
log continuity-check mep changes
no log continuity-check mep changes
Syntax Description
This command has no keywords or arguments.
Command Default
Logging is disabled
Command Modes
CFM domain service configuration (config-cfm-dmn-svc)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
This command enables logging of state changes that occur in MEPs for a particular service, such as:
•
New peer MEP detected.
•
Peer MEP time out (loss of continuity) detected.
If a Local MEP is receiving Wrong Level CCMs, then a transient timeout might occur when correct Level
CCMs are received again.
Note
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable logging of continuity-check mep changes:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet cfm
RP/0/RSP0/CPU0:router(config-cfm)# domain Domain_One level 1 id string D1
RP/0/RSP0/CPU0:router(config-cfm-dmn)# service Bridge_Service bridge group BD1 bridge-domain
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
266
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
log continuity-check mep changes