Examples
The following example shows how to configure an APS group for unidirectional mode:
RP/0/RSP0/CPU0:router(config)# aps group 1
RP/0/RSP0/CPU0:router(config-aps)# unidirectional
Related Commands
DescriptionCommand
Adds an automatic protection switching (APS) group and enter APS
group configuration mode.
aps group (global), on page 842
Displays the operational status for all configured SONET APS
groups.
show aps, on page 893
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
931
SONET Controller Commands on the Cisco ASR 9000 Series Router
unidirectional
To Next Page
Loading...
