Cisco ASR 9000 Series Command Reference Guide

DescriptionCommand
Configures the amount of time before a STS path delay trigger alarm
is cleared.
delay clear, on page 859
Configures a time value for the STS path delay trigger.delay trigger, on page 861
Sets the SONET path overhead bytes in the frame header to a specific
standards requirement or to ensure interoperability with equipment
from another vendor.
overhead (SONET path), on page 878
Configures whether or not selected SONET alarms are logged to the
console for a SONET path controller.
report (SONET path), on page 888
Disables payload scrambling on a SONET path.scrambling disable (SONET path), on
page 892
Sets the bit error rate (BER) threshold values of the specified alarms
for a SONET path.
threshold (SONET path), on page 925
Enables automatic insertion of P-UNEQ code (0x00) in the sent
SONET path overhead C2 byte.
uneq-shut (SONET path), on page 929
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
885
SONET Controller Commands on the Cisco ASR 9000 Series Router
path (SONET)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model