Task ID
OperationsTask ID
readppp
Examples
The following example shows how to display the ICSSO states for PPP running under a redundancy group:
RP/0/RSP0/CPU0:router# show ppp sso state location 0/3/cpu0
Not-Ready : The session is not yet ready to run as Active or Standby
S-UnNegd : In Standby mode, no replication state received yet
A-Down : In Active mode, lower layer not yet up
Deact'ing : Session was Active, now going Standby
A-UnNegd : In Active mode, not fully negotiated yet
S-Negd : In Standby mode, replication state received and pre-programmed
Act'ing : Session was Standby and pre-programmed, now going Active
A-Negd : In Active mode, fully negotiated and up
- : This layer not running
SSO-Group 1 | of-us of-peer
Sess-ID Ifname | LCP auth auth IPCP
--------------------------------+-------------------------------------------
1 Multilink0/3/0/0/100 : S-Negd S-Negd S-Negd S-Negd
2 Multilink0/3/0/0/101 : S-UnNegd S-UnNegd S-UnNegd Not-Ready
3 Serial0/3/1/3/1 : S-Negd S-Negd S-Negd -
4 Serial0/3/1/3/2 : A-Negd A-Negd A-Negd A-UnNegd
5 Serial0/3/1/3/3 : A-Down Not-Ready Not-Ready -
6 Serial0/3/1/3/4 : A-Up A-Up A-Up A-Up
SSO-Group 1 | of-us of-peer
Sess-ID Ifname | LCP auth auth IPCP
--------------------------------+-------------------------------------------
1 Multilink0/3/0/0/102 : S-Negd S-Negd S-Negd S-Negd
2 Serial0/3/1/3/5 : S-Negd S-Negd S-Negd -
3 Serial0/3/1/3/6 : A-Negd A-Negd A-Negd A-UnNegd
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
768
PPP Commands onthe Cisco ASR 9000 Series Router
show ppp sso state
To Next Page
Loading...
Need help?
General
