Cisco ASR 9000 Series Command Reference Guide

Related Commands
DescriptionCommand
Configures the primary and secondary DNS IP addresses for
the IPCP.
ppp ipcp dns, on page 727
Disables installation of a route to the peer address negotiated
by IPCP.
ppp ipcp neighbor-route disable, on page 728
Specifies the default IPv4 address that is assigned to the peer
by the IPCP.
ppp ipcp peer-address default, on page 729
Configures the hostname for MS-CHAP authentication on an
interface.
ppp ms-chap hostname, on page 738
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
747
PPP Commands onthe Cisco ASR 9000 Series Router
ppp multilink multiclass remote apply

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model