Cisco ASR 9000 Series Command Reference Guide

Examples
The following example enables authentication for APS group 1 in abctown:
RP/0/RSP0/CPU0:router(config)# aps group 1
RP/0/RSP0/CPU0:router(config-aps)# authenticate abctown
Related Commands
DescriptionCommand
Adds an automatic protection switching (APS) group and enter APS
group configuration mode.
aps group (global), on page 842
Assigns local SONET physical ports as SONET APS channels in the
current APS group.
channel local, on page 849
Assigns a port and interface that is physically located in a remote router
as a SONET working or protect APS channel.
channel remote, on page 851
Displays the operational status for all configured SONET APS groups.show aps, on page 893
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
847
SONET Controller Commands on the Cisco ASR 9000 Series Router
authenticate (PGP)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model