Cisco ASR 9000 Series - Page 1031

Examples
The following example shows how to select AMI as the T1 line-code type:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/1/1
RP/0/RSP0/CPU0:router(config-t1)# linecode ami
The following example shows how to select HDB3 as the E1 line-code type:
RP/0/RSP0/CPU0:router(config)# controller e1 0/4/1/1
RP/0/RSP0/CPU0:router(config-e1)# linecode hdb3
Related Commands
DescriptionCommand
Displays information about the E1 links and hardware and software
drivers for the E1 controller.
show controllers e1, on page 1034
Displays information about the T1 links and hardware and software
drivers for the T1 controller.
show controllers t1, on page 1046
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1011
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
linecode