Cisco ASR 9000 Series Command Reference Guide

RP/0/RSP0/CPU0:router(config-e1)# lnm major-warning clear line-code-violation 1400
path-code-violation 95 duration 30
Related Commands
DescriptionCommand
Clears link noise monitoring statistics or resets states.clear controller lnm, on page 959
Configures an E1 controller and enters E1 configuration mode.controller e1, on page 970
controller t1, on page 974
Enables link noise monitoring and specifies thresholds for noise
errors on T1/E1 links that are used to signal minor warning events
and recovery from those events.
lnm minor-warning, on page 1015
Enables logging of link noise monitoring major, remove, and minor
events and alarms.
lnm syslog, on page 1021
Displays information about the E1 links and hardware and software
drivers for the E1 controller.
show controllers e1, on page 1034
Displays information about LNM on T1 or E1 links.show controllers lnm, on page 1042
Displays information about the T1 links and hardware and software
drivers for the T1 controller.
show controllers t1, on page 1046
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1014
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
lnm major-warning

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model