Cisco ASR 9000 Series Command Reference Guide

The following example shows configuration of the full 24 timeslots on the 2-Port Channelized OC-12/DS0
SPA, which is required when configuring link noise monitoring:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1e1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1e1-channel_group)# timeslots 1-24
Related Commands
DescriptionCommand
Selects the frame type for an E1 data line.framing (E1), on page 1002
Selects the frame type for a T1 data line.framing (T1), on page 1006
Specifies the speed of the underlying DS0s in a channel group.speed (DS0), on page 1067
Configures a DS0 channel group and enters channel group
configuration mode.
channel-group, on page 957
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1070
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
timeslots

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model