Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to access the POS configuration submode from the POS configuration
mode:
RP/0/RSP0/CPU0:router(config)# interface POS 0/1/0/2
RP/0/RSP0/CPU0:router(config-if)# POS
RP/0/RSP0/CPU0:router(config-if-pos)#
Related Commands
DescriptionCommand
Sets the length of the CRC on a Packet-over-SONET/SDH (POS)
interface.
crc (POS), on page 694
Specifies a number of flag sequences to be inserted between the
packets.
transmit-delay, on page 707
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
703
Packet-over-SONET Interface Commands on the Cisco ASR 9000 Series Router
pos

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model