EasyManuals Logo

Cisco ASR 9000 Series Command Reference Guide

Cisco ASR 9000 Series
1138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #783 background imageLoading...
Page #783 background image
DescriptionField
Open System Interconnection Control Protocol
(OSICP) state. The possible states that may be
displayed are as follows:
• Initial—Lower layer is unavailable (Down), and
no Open has occurred. The Restart timer is not
running in the Initial state.
• Starting—An administrative Open has been
initiated, but the lower layer is still unavailable
(Down). The Restart timer is not running in the
Starting state. When the lower layer becomes
available (Up), a Configure-Request is sent.
• Closed— OSICP is not currently trying to
negotiate.
• Stopped—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
• Closing—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received. Upon
reception of a Terminate-Ack, the Closed state
is entered. Upon the expiration of the Restart
timer, a new Terminate-Request is transmitted,
and the Restart timer is restarted. After the
Restart timer has expired Max-Terminate times,
the Closed state is entered.
• Stopping—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
Req-Sent.
• ACKsent—OSICP has received a request and
has replied to it.
• ACKrcvd—OSICP has received a reply to a
request it sent.
• Open—OSICP is functioning properly.
OSICP
IPv4 address for the peer equipment.Peer IPv4 address
Maximum receive unit. The maximum size of the
information transported, in bytes, in the PPP packet
received by the peer equipment.
Peer MRU
Configuration request was sent; waiting for peer to
respond.
Req-Sent
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
763
PPP Commands onthe Cisco ASR 9000 Series Router
show ppp interfaces

Table of Contents

Other manuals for Cisco ASR 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 9000 Series and is the answer not in the manual?

Cisco ASR 9000 Series Specifications

General IconGeneral
SeriesASR 9000
CategoryNetwork Router
Modular DesignYes
RedundancyYes (Hardware and Software)
Operating SystemCisco IOS XR
Interfaces/Ports10G, 40G, 100G, 400G Ethernet
Expansion SlotsVaries by model
Routing ProtocolBGP, OSPF, IS-IS, EIGRP
ManagementCLI, SNMP, NETCONF
Power SupplyRedundant
Port DensityVaries by model
Power Supply OptionsAC, DC
MemoryVaries by model
StorageVaries by model
DimensionsVaries by model
WeightVaries by model

Related product manuals