Cisco ASR 9000 Series - Page 911

Examples
The following example shows how to enable APS to revert to the protect or working channel after 5 minutes
have elapsed:
RP/0/RSP0/CPU0:router(config)# aps group 1
RP/0/RSP0/CPU0:router(config-aps)# revert 5
Related Commands
DescriptionCommand
Adds an automatic protection switching (APS) group and enter APS
group configuration mode.
aps group (global), on page 842
Displays the operational status for all configured SONET APS
groups.
show aps, on page 893
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
891
SONET Controller Commands on the Cisco ASR 9000 Series Router
revert